Thread: Autoseal help?
View Single Post
Old December 19th, 2008, 03:27 PM
Hookah Pirate's Avatar
Hookah Pirate
Status: Offline
Hookah Newbie
Join Date: Dec 2008
Location: Carson City, NV
Posts: 11
Send a message via AIM to Hookah Pirate
Default Re: Autoseal help?

Why do you want to remove the bearing? Is it rusted? I have a 16" stargate with the auto-seal and the angle of the hose adapters is too low to allow the bearings to slide back in place so I took them out. On mine the hose adapters simply unscrew from the stem halfway through. Mine also has a screen in place to keep the bearings in place but since I removed the bearings anyway I simply cut the screen out to improve airflow. If there is no way to detach it you can use a dremel with a cutting type drill bit to remove the tabs holding the screens.

Last edited by Hookah Pirate; December 19th, 2008 at 03:29 PM.
Reply With Quote