Thread: bowl repair?
View Single Post
Old June 13th, 2009, 02:29 PM
Shienhausser's Avatar
Status: Offline
Hookah Enthusiast
Join Date: Mar 2009
Location: NY/TX
Posts: 1,422
Send a message via AIM to Shienhausser
Default Re: bowl repair?

JBW resists I believe up to around 300*c HOWEVER I have a hard time believing that it would not give off fumes/smoke/taste while under direct heat from coals (wich get VERY hot). It's used alot in the auto industry where the previous concerns are not really as important in the engine bay etc.

It's a great product but Id refrain from using it on products used in inhalation and stick with using it for car repair. Could you not have built up a small layer of foil where the chip is so that it evens out? saving 12$ on a new bowl is not worth the risk of inhaling burning epoxy IMO.

Last edited by Shienhausser; June 13th, 2009 at 02:32 PM.
Reply With Quote