View Single Post
Old August 28th, 2009, 01:33 AM
Status: Offline
Hookah Pro
Join Date: Jun 2009
Location: OC
Posts: 541
Default Re: The Nammor hose hype?

The restriction in the Razan/Nammor/Narbish hoses is in the acrylic tips. They come with holes ~9/32"-5/16" whereas the inner diameter of the hose is ~1/2". If you are handy with a drill, you can bore them out to improve the draw. Just be careful as the acrylic can crack/chip and the thicknesses at the thinnest points do vary from tip to tip. It's less likely to chip by drilling from both ends of each piece but getting the holes to line up in the middle requires careful and accurate drilling.

My Razan and one of my Narbish hoses have been bored out to ~13/32" at the thinnest point. IMO the improvement is very noticeable.
Reply With Quote