Thread: bell problem
View Single Post
Old December 21st, 2009, 09:33 PM
FusionX's Avatar
Status: Offline
Hookah Enthusiast
Join Date: Oct 2008
Location: Central Jersey
Posts: 1,341
Send a message via AIM to FusionX
Default bell problem

Hi all I was wondering if it was safe to solder my bell on my KM. It hasn't broken off, but it was welded on bad and I can move it around. When I check for leaks water spits out of the bell part. This is because water slowly drips into the bell. This should be a quick fix, but once again... is soldering safe? The inner pipe itself is fine, but when once again I check for leaks, the bell leaks air.

This is a second replacement for my trimetal which the first one has severe hose port leaks and other issues.
I'm not gonna send this one back lol cause mahir will kill me.
Also this one was sent straight out of KM
Favorite Tobacco:
Tangiers - Pear, Orange Soda
Nakhla - Double Apple

Last edited by FusionX; December 21st, 2009 at 09:36 PM.
Reply With Quote