View Single Post
  #5  
Old December 29th, 2009, 01:31 AM
SonOfGram's Avatar
SonOfGram
Status: Offline
Hookah Aficionado
 
Join Date: Nov 2009
Location: NYC
Posts: 1,780
Default Re: KM purge valve problem

The purge valve itself is a separate part from the small tube that goes through the heart, it's just welded to it, so while the tube can be bent (into an oval, or not a perfect circle) the valve itself should be perfectly round at the threaded end or the cap won't screw on.

I say post a pic of the top of your valve (without the cap), even if it's dark
__________________

How-To Etch a Hookah Base: http://www.hookahpro.com/forum/showthread.php?t=22782
How-To DIY E-Cigarette: http://www.hookahpro.com/forum/showthread.php?t=33454
Reply With Quote