View Single Post
Old December 29th, 2009, 02:17 AM
Status: Offline
Join Date: Jun 2009
Location: SO. CAL
Posts: 692
Send a message via AIM to Jride
Default Re: KM purge valve problem

Originally Posted by SonOfGram View Post
You could also plop some jb weld (or any other not too runny epoxy) at the opening, avoiding the top and outside threaded edges, which will esentially cover the hole inside entirely and then drill a hole through the epoxy, this'll give you a perfect circle and keep the bent edges where the air is leaking filled.
I can try something like this.. Its kinda scary (dont wanna mess up my new rig ya know)

So ur saying just fill the hole then drill or poke a perfect circle thru it?
Reply With Quote