View Single Post
  #10  
Old December 29th, 2009, 02:23 AM
SonOfGram's Avatar
SonOfGram
Status: Offline
Hookah Aficionado
 
Join Date: Nov 2009
Location: NYC
Posts: 1,780
Default Re: KM purge valve problem

Yep. If you'll be using jb weld though, mix it and then let it sit for a few until it hardens just a bit and isn't so runny, then apply, otherwise you'll drip a bunch into the pipe and have bigger problems Fill the hole and turn the stem upside down to let it cure, if anything does drip, you can just sand the run off afterwords.
__________________

How-To Etch a Hookah Base: http://www.hookahpro.com/forum/showthread.php?t=22782
How-To DIY E-Cigarette: http://www.hookahpro.com/forum/showthread.php?t=33454
Reply With Quote