View Single Post
Old December 29th, 2009, 02:29 AM
Status: Offline
Join Date: Jun 2009
Location: SO. CAL
Posts: 692
Send a message via AIM to Jride
Default Re: KM purge valve problem

Originally Posted by SonOfGram View Post
Yep. If you'll be using jb weld though, mix it and then let it sit for a few until it hardens just a bit and isn't so runny, then apply, otherwise you'll drip a bunch into the pipe and have bigger problems Fill the hole and turn the stem upside down to let it cure, if anything does drip, you can just sand the run off afterwords.
Grrrrrrrr.. Sorry man, Im just raged right now. The whole situation makes me mad.

I dont wanna risk ruining my pipe, but Its not enjoyable to smoke when all Im thinking bout is how the purge leaks and Im not getting the smoke I should be.

I might have to do the JB weld thing then.

Any other suggestions are welcome!
Reply With Quote