View Single Post
Old December 29th, 2009, 01:50 PM
Mackmaven's Avatar
Status: Offline
Hookah Aficionado
Join Date: Feb 2009
Location: Mar Vista, CA
Posts: 1,646
Default Re: KM purge valve problem

i would go at it with pliers, a nailset or a punch firt and see it i couldn't just round out the inside with a little pressure, if not that then the jb weld isn't a bad plan. U can always just make a little flap lid, same effect as a bb, the suction will keep it down and seal the chamber...

"From zero to hookah, in nothing flat."
Reply With Quote