View Single Post
Old June 20th, 2008, 01:04 PM
vegasvic's Avatar
Status: Offline
Hookah Nut
Join Date: May 2008
Posts: 401
Default Re: The Windcover and You

When I look at these things it reminds me of something I could have made in junior high metal shop class -- its rolled sheet metal with a few vents cut out and held together by a couple of spot welds. I'd really like to get a nice, ornate one that has a good handle and would fit over a phunnel bowl on a KM. It shouldn't be too difficult to commission somebody to make some windcovers (I would, but I don't know any junior high kids who pay attention in shop class).

The balancing act on top of tongs is eventually going to cause a tipping incident, and I don't think I have Larry's quick reflexes....
Reply With Quote