View Single Post
  #11  
Old September 21st, 2007, 05:33 PM
boomhauer
Status: Offline
Banned
 
Join Date: Aug 2007
Posts: 946
Send a message via AIM to boomhauer Send a message via Yahoo to boomhauer
Default Re: Straightening out a Nammor

really you just need to give them a constant high heat. what you can do is tie it to a straight pole and keep it tight then apply a constant high heat. this will make the plastic lose its memory from before and it will go straight. just remember, a constant high heat.
Reply With Quote