View Single Post
Old December 1st, 2008, 03:10 PM
nmcgrawj's Avatar
Status: Offline
Hookah Nut
Join Date: Nov 2008
Location: Detroit, Mi
Posts: 215
Default Re: Chamber type question

There's chinese pipes that have a ball bearings in the hose port too?

I believe my hookah was chinese made. You saw the one i made in my other thread. The hose port is open to the inside of the "junction" part that goes on top of the vase, and the other port has a ball bearing inside with a cap that screws on top.

So i understand a traditional setup will purge MUCH better than mine, but i was trying to figure out the draw aspect. And if the hole that leads to the hose part is reasonably small, thats why a KM could be superior correct?
Reply With Quote